TrackXC

Blog

How to make a cross country course map spectators can actually use

The typical cross country course map is a screenshot of a satellite view with a coloured line on it, posted as a PDF on the host school's website a week before the meet. Coaches can read it. Almost nobody else can.

A spectator on race day has different questions. Where can I see my kid? How long until the runners come back past here? Can I cross this path? Where are the restrooms? A good course map answers those questions, and it has to answer them on a phone held in one hand.

Start from an accurate route

The line on the map is the foundation, and it should be the route the runners actually run, not a sketch.

  • Record it. Walk or jog the course with a GPS watch or a phone app that exports GPX, after the course is marked. Hug the inside of the turns, the way runners do.
  • Or trace it carefully over a satellite view, using the flags and paths you can see. If you're working from an old hand-drawn map, lay it over the satellite image and line up landmarks: buildings, path junctions, tree lines.
  • Show the direction. Arrows along the route stop the most common misreading, which is following a loop the wrong way round.
  • Mark distances. Mile or kilometre markers on the line let spectators judge where in the race the runners are when they pass.

Courses that run the same loop twice, or pass the same field several times, are the hardest to read. Make sure each lap is clear, and say which lap passes where.

Mark the viewing spots

This is the part most maps leave out, and it's the part spectators need most. Walk the course and look for places where:

  • the course passes close to itself, so spectators can see the runners twice with a short walk;
  • spectators can stand well back from the route without blocking it;
  • runners are doing something worth watching: a climb, a downhill, a tight turn, the final straight.

Three or four marked spots is enough. Give each a plain name people can say out loud: "the pond corner", "the back hill", "the lap gate".

Show the things people will look for

Beyond the course itself, spectators will look for:

  • parking, and where buses unload;
  • restrooms;
  • the team camp area;
  • the start, the finish, and where to meet runners after the race;
  • medical and the athletic trainer;
  • places where they may and may not cross the course.

Keep the symbols simple and few. A map with fifteen kinds of icons is a map nobody reads.

Make it work on a phone

A PDF that has to be zoomed and dragged is a poor fit for someone standing in a field. If you can, publish the map so that it opens in a phone's browser, with:

  • the phone's own location shown on it, so people can see where they are relative to the course;
  • the race schedule next to it;
  • a link that fits on a QR code, posted at the entrance and on the heat sheet.

Signal at cross country venues is often poor, so the map should still be readable if the background imagery doesn't load.

Tell people when, not just where

The most useful thing a course map can do on race day is connect place to time. If the leaders are expected to run 5K in about 16 minutes, a viewing spot at the two-mile mark sees them about 10 minutes after the gun, and the back of the field several minutes later. Writing those times next to each viewing spot, per race, tells parents when to start walking.

Tools built for this, like TrackXC, do the arithmetic for you: set the expected winning time and last-finisher time for each race, start the clock at the gun, and each spectator's phone shows where the field should be and which viewing spot they can still reach in time.

Checklist

  • Accurate route with direction arrows and distance markers
  • Each lap clear, on courses that repeat a loop
  • Three or four named viewing spots
  • Parking, restrooms, team area, medical, start and finish
  • Places to cross, and places not to
  • Opens on a phone, from a QR code, without an app
  • Expected times at each viewing spot, per race